Poly(ethylene oxide) (PEO) is a well-known biocompatible polymer and has widely been used for medical applications. Recently, we have investigated the dynamic behavior of hydration water in the vicinity of PEO chains at physiological temperature and shown the presence of slow water with diffusion coefficient one order of magnitude less than that of bulk water. This could be evidence for the intermediate water that is critical for biocompatibility; however, its detailed dynamical features were not established. In this article, we analyze the quasi-elastic neutron scattering from hydration water through mode distribution analysis and present a microscopic picture of hydration water as well as its relation to cold crystallization.

Poly(2-methoxyethyl acrylate) (PMEA) is a US FDA-approved biocompatible polymer, although there is insufficient work on human umbilical vein endothelial cells (HUVECs) and platelet interaction analysis on PMEA-analogous polymers. In this study, we extensively investigated HUVEC–polymer and platelet–polymer interaction behavior by measuring the adhesion strength using single-cell force spectroscopy. Furthermore, the hydration layer of the polymer interface was observed using frequency-modulation atomic force microscopy. We found that endothelial cells can attach and spread on the PMEA surface with strong adhesion strength compared to other analogous polymers. We found that the hydration layers on the PMEA-analogous polymers were closely related to their weak platelet adhesion behavior. Based on our results, it can be concluded that PMEA is a promising candidate for the construction of artificial small-diameter blood vessels owing to the presence of IW and a hydration layer on the interface.

Elucidating the state of interfacial water, especially the hydrogen-bond configurations, is considered to be key for a better understanding of the functions of polymers that are exhibited in the presence of water. Here, an analysis in this direction is conducted for two water-insoluble biocompatible polymers, poly(2-methoxyethyl acrylate) and cyclic(poly(2-methoxyethyl acrylate)), and a non-biocompatible polymer, poly(n-butyl acrylate), by measuring their IR spectra under humidified conditions and by carrying out theoretical calculations on model complex systems. It is found that the OH stretching bands of water are decomposed into four components, and while the higher-frequency components (with peaks at ∼3610 and ∼3540 cm-1) behave in parallel with the C═O and C-O-C stretching and CH deformation bands of the polymers, the lower-frequency components (with peaks at ∼3430 and ∼3260 cm-1) become pronounced to a greater extent with increasing humidity. From the theoretical calculations, it is shown that the OH stretching frequency that is distributed from ∼3650 to ∼3200 cm-1 is correlated to the hydrogen-bond configurations and is mainly controlled by the electric field that is sensed by the vibrating H atom. By combining these observed and calculated results, the configurations of water at the interface of the polymers are discussed.

There is a long, ongoing debate on how small molecules (osmolytes) affect the stability of proteins. The present study found that change in collective rotational dynamics of water in osmolyte solutions likely has a dominant effect on protein denaturation. According to THz spectroscopy analysis, osmolytes that stabilize proteins are accompanied by bound hydration water with slow dynamics, while the collective rotational dynamics of water is accelerated in the case of denaturant osmolytes. Among 15 osmolytes studied here, there is a good correlation between the change in mobility in terms of water rotational dynamics and the denaturation temperature of ribonuclease A. The changes in water dynamics due to osmolytes can be regarded as a pseudo-temperature-change, which agrees well with the change in protein denaturation temperature. These results indicate that the molecular dynamics of water around the protein is a key factor for protein denaturation.

In some synthetic polymers used for medical applications, hydration water in the vicinity of the polymer chains is known to play an important role in biocompatibility and is referred to as intermediate water. The crystallization of water below 0 °C observed during thermal analysis has been considered as evidence of the presence of intermediate water. However, the origin and physicochemical properties of intermediate water have not yet been elucidated. In this study, as a typical biocompatible polymer, poly(ethylene oxide) and its hydration water were investigated with the use of terahertz time-domain spectroscopy and quasi-elastic neutron scattering. The obtained results prove the existence of a significant amount of mobile water that interacts with the polymer chains even when the water content is low at physiological temperatures.

Intermediate water (IW), which is formed not only by biocompatible polymers such as poly(2-methoxyethyl acrylate) (PMEA), but also by biomacromolecules, plays a key role in determining the biocompatibility of synthetic polymers. In this study, we compare the well-defined linear and cyclic PMEA using differential scanning calorimetry and atomic force microscopy. This study aims to clarify the role of the chain-end effect in IW formation to establish design guidelines for biomaterials.

The dynamic behavior of water molecules and polymer chains in a hydrated poly(methyl methacrylate) (PMMA) matrix containing a small amount of water molecules was investigated. Water molecules have been widely recognized as plasticizers for activating the segmental motion of polymer chains owing to their ability to reduce the glass transition temperature. In this study, combined with judicious hydrogen/deuterium labeling, we conducted quasi-elastic neutron scattering (QENS) experiments on PMMA for its dry and hydrated states. Our results clearly indicate that the dynamics of hydrated polymer chains are accelerated, and that individual water molecules are slower than bulk water. It is therefore suggested that the hydration water affects the local motion of PMMA and activates the local relaxation process known as restricted rotation, which is widely accepted to be generally insensitive to changes in the microenvironment.